End-of-line/end-of-run modules .... CHEAP STUFF!

  • DV3 (PCB/panel - partial build)

    Same old DV3, but in a cheaper (and cheaper to ship!) form - all SMD components presoldered by the fabricator, just add through-hole components to finish the build.

    Get the DV3 partial build 
  • SEQ8.2 (PCB/panel - partial build)

    Grab yourself a sequencer in a cheap, easy to ship format - all SMD parts have been pre-soldered by the fabricators, leaving you to supply through-hole components (pots etc.) to finish the build.

    Get the SEQ8.2 partial build 
  • SEQ4.2 (PCB/panel - partial build)

    The smaller sibling of the 8-step sequencer in partial build form. All SMD components pre-soldered by the fabricator, just supply the appropriate through-hole parts to complete the job.

    Get the SEQ4.2 partial build 
  • SINdrone

    4 sine oscillators in a single unit - individual and mixed outputs available, complete with individual gain and pitch controls. There are jumpers on the rear of the board if you want to hack voltage control onto it.

    Drone on ...

    Get the SINdrone 
  • XO106r5

    4 AVR-based square/pulse oscillators with voltage-controlled pitch and pulsewidth, a patchable logic matrix and a Sallen-Key filter if you want to use it.

    It's hackable too - the firmware is available under a permissive license. Also available as a PCB/panel set.

    Get the XO106r5 
  • XO106r4.5

    A blast from the past - four CMOS oscillators of varying pitches, a switchable filter and current starve if you want things to get really weird.

    Makes a great source for clashy, DIY percussion sounds.

    Get the XO106r4.5 
  • Quite Small LFO

    An analogue LFO in 2HP - capable of generating both square/pulse and saw/triangle waveforms in various speeds from 'slow' to 'maybe not as slow as all that'. Also works well as a system clock generator.

    Get the Quite Small LFO 
  • TinyDVCO

    A VCO, albeit a microcontroller-based one, in 2HP? Yes indeed - does pretty well in the 'amount of noise generated per HP' stakes ... the firmware is hackable, too.

    Get the TinyDVCO 
  • Quite Small Gate

    A dual manual gate module in 2HP - use it to reset sequencers, one-shot envelope generators and literally tens of other uses (maybe)

    Go push yer buttons ...

    Get the Quite Small Gate 
1 3