Free UK Shipping.

4HP dual sample-and-hold - PCB and panel set


Note that this is a PCB/panel only - it is up to you to source appropriate components and build the module up.

PCB and panel set for a dual sample-and-hold/track-and-hold circuit using the tried and tested LF398 sample and hold amplifier - both channels are independent of each other and are configured such that 5V+ on the trigger will 'sample', with ground being 'hold'. If you want to get the classic stepped bleepy random voltages then you need a noise source too ...

This is a fairly simple build - all of the parts are readily available, although I advise shopping around for LF398s as they're relatively expensive and prices seem to vary. A lot.

The spacing of the two ICs is such that things might be a bit tight with certain DIL sockets, turned-pin types in particular - if you're feeling confident then you can just solder the ICs straight to the PCB.

As with most of my other modules, the panel is made from laser-cut 3mm perspex, suitably engraved.

You can get panel files, BOM etc. from here:

£0.00 £11.99
Earn 0 reward points

The item has been added to your basket

Continue Shopping
Proceed To Checkout
  • Paypal
  • Mastercard
  • Visa
  • Maestro