Hand-built and bespoke Eurorack

Currency
Hand-built and bespoke Eurorack
Cart 0
VCP: Protoype voltage-controlled panner module (6HP)
VCP: Protoype voltage-controlled panner module (6HP)
VCP: Protoype voltage-controlled panner module (6HP)
VCP: Protoype voltage-controlled panner module (6HP)
VCP: Protoype voltage-controlled panner module (6HP)
York Modular

VCP: Protoype voltage-controlled panner module (6HP)

2 in stock.

Regular price £39.99 £0.00 Unit price per
Tax included. Shipping calculated at checkout.

IMPORTANT: these are prototype builds - in other words, they were built to make sure that the whole thing works correctly and without paying too much attention to matching transistors (ie. I used whatever came to hand).

The voltage-controlled panner - a module with many uses throughout the home: use it to split a signal into two separate channels for processing (eg. send one output straight to a mixer and the other through a filter) or even as a slightly braindead VCA by only using the 'right' channel.

The control voltage range is 0-10V, with 0V being 'full left' and 10V being 'full right' - there's a trimmer potentiometer on the main board which allows you to adjust the left-channel gain. Negative CVs will be rejected, so if you're using a through-zero control voltage then you may need to apply an offset to your CV.

Please note that this module takes a mono, not stereo, input - what it does is split the signal into 'left' and 'right' channels which can be sent to two other sources.

Supplied with mounting hardware, a power cable and a panel fabricated from 1.6mm FR4 (PCB material). The panel is 6HP wide