Hand-built and bespoke Eurorack

Currency
Hand-built and bespoke Eurorack
Cart 0
THAT-2180 based VCA (updated design, 4HP)
THAT-2180 based VCA (updated design, 4HP)
THAT-2180 based VCA (updated design, 4HP)
THAT-2180 based VCA (updated design, 4HP)
York Modular

THAT-2180 based VCA (updated design, 4HP)

Regular price £45.99 £0.00 Unit price per
Tax included. Shipping calculated at checkout.

An updated version of my THAT2180 VCA module.

Unlike some others, this module is built around the THAT2180 Blackmer cell IC - I find it easier to use, and less prone to self-destruction, than the V2164. This is a 100% through-hole build, with everything included including a THAT2180C IC - there are a couple of different versions of the THAT2180 (A and B) but unless you're looking for insanely low levels of THD the C variant gives the best bang for the buck, so that's what I've included.

Unlike the previous incarnation of the module, this one now sits behind a 4HP panel and the layout has been slimmed down a bit too; there's a signal in (obviously) and a single CV input with an associated attenuator. Should you need to perform any additional calibration, there's a trimpot on the rear of the module.

These modules are built with Alpha 9mm potentiometers and Befaco micro knobs. In common with my other modules, the panel is fabricated from laser-cut and engraved 3mm black perspex. A power cable is also included.

Dual and quad versions of this module are also available, but note that the quad version is a special order only.