RUSTYSEQ: Distressed-look 4-step CV sequencer with reset (4HP)
1 in stock.
THESE MODULES ARE ONE-OFFS - they feature a 1.8mm thick 3D-printed panel faced with rust-effect decoupage paper. The end result has a glossy finish - whilst the finish is pretty sturdy it isn't indestructable, so try and avoid excessive handling.
You can get the regular version of the module here
A revamped version of my original 4-step CV sequencer.
Nothing flash here, just a regular sequencer with four steps, a reset input and an output - no muss, no fuss. Plus, it fits behind a 4HP panel.
The obligatory blinkenlights are present and correct, too. Trigger and clock require at least 5V to activate (more is better, within reason) and some clock sources may require buffering - this is highly dependent on the source, though.
Both clock and reset will trigger on the rising edge of an incoming signal - furthermore, the sequencer will be held at step 1 for as long as the reset signal is high. Counting will not resume until the reset signal goes low again.
Power cable and mounting hardware are supplied.
CURRENT CONSUMPTION: varies with clocking speed - figure on 15-20mA (+12). Does not use -12V.