Free UK Shipping.

AVR-VCO: PCB set for AVR-based wavetable VCO (3HP)


Information

This is a PCB set only. You will need to fabricate an appropriate panel and source suitable components for the build - in addition, you may also need to purchase a firmware IC if you don't have the means to flash your own.

Analogue VCO cores are a pain in the ass to build so this is based around a microcontroller instead - cheating? Maybe so, but it's pretty damned versatile and if you have the knowledge to program microcontrollers then you can hack it to your heart's content. What makes things a bit more interesting is that both the output frequency and the waveform can be voltage controlled - normally, the waveform would be selected via a pot alone, but I decided it would be interesting to allow voltage controlled waveform selection too. Just because.

As supplied, the module can provide six different output waveforms: sine, triangle, square, sawtooth, something pulse-ish and digital noise - waveform selection is either via the pot _or_ it can be voltage controlled. If you want to get down and dirty with the code then you could easily replace the wavetables with something else. It'll track 1V/octave pretty well over 5 octaves, this being governed by the fact that microcontrollers tend to get a bit upset if you feed more than 5V to their input pins.

There are three inputs (CV, Wave and OP) - the OP input can be used to do interesting things, although by default it'll allow you to alter the duty cycle of the square-wave output and introduce some nasty-sounding distortion into everything else.

In addition, these modules were designed to fit behind 2HP panels however in some cases there's a risk of interference with adjacent modules particularly if these modules have PCBs which are the full width of their panel, so they're supplied with a 3HP panel as standard.

The schematic, source and BOM for the module can be found here, as can panel files: https://bitbucket.org/yorkmodular/avr-vco-diy/src/master/

Once assembled, the module is 47mm deep from the rear face of the panel to the rear edge of the power connector. Please bear this in mind if you're using a shallow skiff system.

£0.00 £9.99
Earn 0 reward points

The item has been added to your basket

Continue Shopping
Proceed To Checkout
  • Paypal
  • Mastercard
  • Visa
  • Maestro